SNMP Data Monitoring – Self-Health Configuration

For CA Nimsoft Monitor

The SNMP Data Monitoring (snmpcollector) probe self-health metrics are always on by default. If you do not want to collect and view this information, you can disable self-monitoring metrics in raw config.

Follow these steps:

1. Open the probe configuration in Raw Configure.
2. Expand the self_health node.
   The system displays the available self-health metrics.
3. Change the status attribute for the metric:
   enable – The metric is on and monitoring the probe
   disable – The metric is off and not monitoring the probe
   Important! Only change the metric status. If you change any other information, you could collect incorrect data.
4. Select Apply.
5. Restart the probe to complete the configuration.
   The SNMP Data Monitoring probe updates the status settings when the probe starts.

For more information, see the Probe Guide for SNMP Data Monitoring.